Discuss Raspberry Pi / Linux development using the H1-Interface
I recently bought a H1 interface and it works perfectly!
I have a question regarding the pulse inputs on the interface. Is there any schematics for a minimal LED-reading circuit that can be used? Unfortunately my heat pump and my electricity meter is a couple of meters away from each other. Will cable length be an issue?
- Posts: 1
- Joined: Thu Dec 22, 2016 20:48
Cable length will not be an issue. I use a normal "tele cable" EKKX and have over 10 meters. No problem.
It should be possible to find a light sensor circuit by googling. But I know it may be a little tricky to set up. Cable connected to S0 connector on meter is the best.
- Site Admin
- Posts: 22
- Joined: Tue Mar 14, 2006 11:38
Return to H1 and Raspberry Pi
Who is online
Users browsing this forum: No registered users and 1 guest